Table of Contents
Advertisement
INTRODUCTION
1.3 Names of Camera Parts
1. Conduit hole used for surface run power/video connector
2. Bottom case
3. Camera housing
4. Dome cover
5. IR board
a. AC 24V / DC 12V power input connector (red +, black -)
b. Video output connector
Note: See Figure 2-3 for camera board controls.
1.4 Routine Maintenance
• The dome cover is an optical part. Use a soft, dry cloth to remove any fingerprints
or dust.
• Clean the camera housing with a soft, dry cloth. For more stubborn stains, use a
cloth dampened with a small quantity of neutral detergent, then wipe dry.
Caution: Do not use volatile solvents such as alcohol, benzene or thinners to avoid
damaging the surface finish.
Figure 1-1 Camera parts
4
a
b
Advertisement
Table of Contents
