JVC TK-AM200U - Active Movement Color Dome Camera Instructions Manual page 14

3.
Set system setting switches.
Switches
ON
1 2 3 4 5 6 7 8
Switch numbers
Switch 1, 2: System connection
selector switch
Set the system connection selector
switches (Switch 1, 2) in accordance
with the equipment that the camera
body is to be connected to.
Connecting
Switch 1
equipment
RM-P2580
Memo:
Switch 1 and 2 are used to specify the
form of the control signal cable connection
between the remote control unit and the
camera and the communication protocol.
Switch 1 (Initial setting: OFF)
OFF: POINT TO POINT
ON: MULTIDROP
Switch 2: (Initial setting: OFF)
OFF: DUPLEX
(two-way data transmission)
ON: SIMPLEX
(one-way data transmission)
Switch 3: Termination ON/OFF
switch
This is a termination ON/OFF switch
between the "RX+" and "RX–" control
signal connection terminals.
ON: The "RX+" to "RX–" route is ter-
minated by a 110 resistor.
OFF: The RX+ to RX– route is not
terminated.
(Initial setting: OFF)
In a system using the Remote Control Unit
RM-P2580, set this to "ON" only on the
camera placed at the end of the control sig-
nal cable. Set to OFF on all other cameras.
1
ON
1
OFF
Switch 2
ON OFF
4.
If the camera ID numbers of cameras connect
to the RM-P2580 are duplicated, the system
will not work correctly.
5.
Switch 4: Synchronization signal
selector switch
Switches the synchronization method
of the camera image.
OFF: Internal synchronization (INT)
ON: The camera's vertical synchroniza-
tion is matched with the frequency
of the AC 24V line power supply.
When switching between mul-
tiple cameras using a switcher,
selecting this mode and adjust-
ing the vertical phase can re-
duce the monitor sync distur-
bances occurring when the
camera image is switched. (This
cannot be used in regions where
the power frequency is 50 Hz.)
Switches 5, 6, 7, 8
These switches are not used.
(Set them to OFF.)
Camera ID setting switches
Camera ID setting is only performed
when the system connection selector
switches (Switch 1 and 2) are set to "RM-
P2580".
The camera ID number is a number to
identify each of the cameras connect to
the RM-P2580. The camera ID number
should be the same as the number of
the RM-P2580 VIDEO INPUT terminal
to which the camera is connected.
Example:
The camera connected to VIDEO
INPUT 1 is set
to "01" as shown
on the right.
Double
figures
Memo:
When setting of the switches is com-
pleted, close the cover over the setting
switches again.
"0" "1"
0 0
Single
figures
15