Table of Contents
Advertisement
Divar | Installation Manual | Operating instructions
Alarm inputs
If an input causes an alarm
•
Monitors A and B can switch to a pre-programmed view mode.
•
Monitor A: The border around the displayed cameos is red. The alarm icon
is displayed in each cameo. An alarm status message is displayed.
•
Monitor B: Sequenced display of pre-programmed cameras.
•
The alarm beeper sounds. The alarm
•
A controllable camera might be moved to a pre-defined position.
Acknowledging an input alarm
1. Press the acknowledge key
to acknowledge the alarm.
> The beeper is silent.
> The alarm
and
indicators are no longer lit.
> The alarm status message disappears.
> The last-used view mode is restored.
The alarm icon remains visible as long as the input causing the alarm is active.
If an alarm is not acknowledged, the beeper switches off after the dwell time but
the alarm still needs to be acknowledged.
If auto-acknowledge is enabled, the beeper, and the alarm
indicators switch off after the dwell time.
Bosch Security Systems
and the
indicators flash.
and
Motion alarm
If a motion detection signal causes an alarm
•
Monitors A and B can switch to a pre-programmed view mode.
•
Monitor A: The border around the displayed cameos is yellow. The motion
icon is displayed in each cameo. An alarm status message is displayed.
•
Monitor B: Sequenced display of pre-programmed cameras.
•
The alarm beeper sounds. The motion
•
A controllable camera might be moved to a pre-defined position.
Acknowledging a motion alarm
1. Press the acknowledge key
to acknowledge the alarm.
> The beeper is silent.
> The motion
and
indicators are no longer lit.
> The alarm status message disappears.
> The last-used view mode is restored.
The motion icon remains visible as long as the input causing the alarm is active.
If an alarm is not acknowledged, the beeper switches off after the dwell time but
the alarm still needs to be acknowledged.
If auto-acknowledge is enabled, the beeper, and the motion
indicators switch off after the dwell time.
Using motion detection outdoors may cause false alarms because of varying
light conditions.
EN | 3-13
and the
indicators flash.
and
Advertisement
Table of Contents
