Table of Contents
Advertisement
Divar | Installation Manual | Hardware setup
Signal name:
Pin no.
Description
Alarm_in_6
6
Alarm input 6
Alarm_in_7
7
Alarm input 7
Alarm_in_8
8
Alarm input 8
Alarm_in_9
9
Alarm input 9
Alarm_in_10
10
Alarm input 10
Alarm_in_11
11
Alarm input 11
Alarm_in_12
12
Alarm input 12
Alarm_in_13
13
Alarm input 13
Alarm_in_14
14
Alarm input 14
Alarm_in_15
15
Alarm input 15
Alarm_in_16
16
Alarm input 16
Relay1_A
17
Relay 1 output pole 1
Relay1_B
18
Relay 1 output pole 2
Relay2_A
19
Relay 2 output pole 1
Relay2_B
20
Relay 2 output pole 2
Relay3_A
21
Relay 3 output pole 1
Relay3_B
22
Relay 3 output pole 2
Relay4_A
23
Relay 4 output pole 1
Relay4_B
24
Relay 4 output pole 2
System Ground
25
Chassis Ground
Bosch Security Systems
SCSI connection
The unit provides a 50-pin high density SCSI-2 port for connection of an
external storage system, for example, a LP (DVAD) or a RAID (DVAS) storage
array. To use this feature, connect the drive's SCSI cable to the SCSI-2
connector on the rear panel.
The Divar with internal DVD writer is delivered with a terminator connected to
the SCSI connector. Do not remove the supplied terminator from the SCSI
connector unless you connect a disk array!
The default SCSI ID of the Divar is 7. The SCSI ID of the internal DVD writer
is 6. If you are using a disk array make sure that the ID you select is different
from these IDs.
Adding additional storage arrays deletes all existing data!
Specification
Connector type:
50-pin narrow SCSI connector for external SCSI device
Bus format:
Narrow (8 Bits) single-ended
Max. number of SCSI devices:6 (7 when Divar has no internal DVD writer)
Max. transfer rate:
20 Mbytes per second
Total max. cable length:
2 to 4 SCSI devices
5 to 6 (7) SCSI devices 1.5m (uniformly spaced)
The internal SCSI cable length is approximately 17 cm.
This must be taken into account when calculating the
total cable length.
26
1
EN | 4-8
Fast-20
3m (uniformly spaced)
50
25
Panel view
Advertisement
Table of Contents
