Table of Contents
Advertisement
Divar | Installation Manual | Menu system
T
/D
>
IME
ATE
MAIN MENU
TIME/DATE
TIME ZONE
TIME FORMAT
TIME
DATE FORMAT
DATE
SYNCHRONIZE
DAYLIGHT SAVING
START DATE/TIME
END DATE/TIME
OFFSET
•
Select a time zone from the list. (Daylight saving time is adjusted
accordingly.)
•
Fill in the actual time and date.
•
Select either a 12-hour or a 24-hour clock format.
•
Select from three date formats which show either the month (MM), the
day (DD) or the year (YYYY) first.
•
Set Daylight Saving to Yes to enable it. Fill in the day, month and time of
both change-overs and the offset if it differs from the information
associated with your time zone.
>> SYNCHRONIZE
•
Use the Synchronize function to set the time of the unit from the time of
the network. (Synchronize only works if the Divar time is within 7½
minutes of the server time.) Fill in the IP address of the network time
server. If a time server is not present on the same subnet, the Divar
searches for a suitable time server outside its own network. Make sure
the Divar gateway is set correctly to find the time server. Ensure that
firewalls do not block NTP traffic via port 123.
•
The time and date of all other connected units are automatically
synchronized every hour from the time and date of the unit with DVR
ID 1.
Bosch Security Systems
GMT
+01:00 WEST-EUROPE
24 HOUR
14:00:17
YYYY-MM-DD
2002-06-19
YES
LAST SUN MAR 02:00
LAST SUN SEP 03:00
01:00
V
S
>
IEW
ETTINGS
The View Settings menu allows you to set up the display of the individual
cameras. You can also set the sequence in which the cameras are displayed and
the duration. Use the Configure Monitors submenu to set up the monitor
displays.
MAIN MENU
VIEW SETTINGS
CAMERA SETUP
>
SEQUENCES
CONFIGURE MONITORS
>> CAMERA SETUP
Use the Camera Setup menu to access the submenus for setting the camera
names, for locking cameras and for controlling cameras.
>>> Camera name
•
Select a camera by pressing a camera key on the unit. The number
of the camera is the number of the connector at the rear of the unit
to which it is connected.
•
Enter a name for the selected camera. The name can be up to 16
characters long.
>>> Camera lock-out
•
Locked cameras are not visible during normal use.
•
Place a check mark under the number of the camera you wish to
lock or press a camera key on the unit to switch the lock on or off.
•
Select the Set Password submenu and fill in a 4-digit password to
restrict access to the camera lock-out menu.
>>> Camera control
•
Set the Auto Camera Contrast to On to let the system
automatically adjust the contrast for each camera.
•
If you set the Auto Camera Contrast to Off, you can access the
Adjust Contrast submenu.
EN | 5-7
>
>
>
Advertisement
Table of Contents
