Gotcha
Parts
Instructions For Hanging
Step 1
Place poster on a flat surface. Snap the Gotcha
Holder (top and bottom) open so hinge is turned
up as far as possible. Insert graphic completely
into holder until edge of graphic meets top of
holder. To close, snap the Gotcha Holder shut.
Fig. 1
Note: It is easier to open and close the Gotcha
Holder by starting at one end and working your
way down the holder. With large or curling
graphics, it may be easier to insert graphic at one
end and slide into holder from one end to another.
Step 2
Note: For OneUp applications, the Gotcha
Holder is conveniently marked in the center.
Find the mark and insert the OneUp Gotcha Clip
into slot on backside of the top Gotcha only. (You
should hear a "SNAP" when the clips are inserted
properly). Fig. 2
Step 3
Suspend poster.
Important note:
Please save and reuse the Gotcha Holder and
Gotcha Clips for future projects.
The Gotcha® is a registered trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products. Part #99INSGO1UP
Incept-3.1.99
®
OneUp
Gotcha
12G100
®
Instruction Sheet
OneUp Gotcha Clip
1Up-5066
Figure 1
Figure 2
35 Congress Street, Salem MA 01970
Tel# 1-800-631-9707 Fax# 1-800-560-2890
e-mail:signware@rosedisplays.com
Need help?
Do you have a question about the GOTCHA WITH OLD ONEUP GOTCHA CLIPS and is the answer not in the manual?
Questions and answers