ROSE DISPLAYS ANOGOTCHA SQUARE WITH CABLE CLIP AND BALL CHAIN Manual

AnoGotcha™
Parts
Ball Chain
96-0302P
Instructions for Hanging
Step 1
Insert T-Top Gotcha Holder into AnoGotcha
Shell. Fig. 1
Step 2
Insert single ball of ball chain into inner
channel of Cable Clip. The cable should snap
into place. Fig. 2
Step 3
Align one round end of cable clip with top
channel of the aluminum rail and insert.
Once in place, insert end of ball chain into
channel. Then press down on the other
round end of the cable clip and slide into rail
by pushing on the clip. Fig. 3
Note: Be sure to slide the ball chain into
place by pushing on the cable clip. Do not
pull on, or push against, the ball chain as
this will cause it to bind in the channel.
Note: For OneUp Application place
the Cable Clip in the center of the
AnoGotcha Holder.
Step 4
Push end caps into place. Fig. 4
Step 5
Snap the AnoGotcha Holder open and insert
poster (top and bottom). To close, snap the
AnoGotcha Holder shut. Fig. 5
Step 6
Suspend poster. Fig. 6
™
AnoQuick™ and AnoGotcha
trademark of Rose Displays, Ltd. Neither the manufacturer nor any sales
agent may be held liable for injury, loss or damage resulting from the use
of these products. Part #02INSAnoGotchaSQCableClipBallChain
Incept-7.29.02
OneUp Instruction Sheet
AnoGotcha Shell
12AG400SQ
®
are trademarks and Gotcha is a registered
T-Top Gotcha
12GT100
Figure 1
Figure 3
Figure 5
Cable Clip End Caps
06-5050 06-5545
Figure 2
Figure 4
Figure 6
35 Congress Street, Salem, MA 01970
Tel# 1- 800 631-9707 Fax# 1-800-560-2890
e-mail:signware@rosedisplays.com