ROSE DISPLAYS GOTCHA FOR PEGBOARD Manual

GotchaClip™ for Pegboard

Parts

Instructions for Hanging

Instructions for Hanging Instructions for Hanging

Step 1

Place poster on a flat surface. Snap the Gotcha
Holder open and insert poster (top and bottom).
To close, snap the Gotcha Holder shut. Fig. 1
Note: It is easier to open and close the Gotcha
Holder by starting at one end and working your
way down the holder.

Step 2

Insert the GotchaClips into the holes in the peg-
board. For best results, place the GotchaClips in
holes separated by a difference equal to half of the
length of Gotcha Holder. ( i.e. If holder is 12" place
clips 6" apart). Fig. 2

Step 3

Push Gotcha onto clips, you will hear a "SNAP".
Fig. 3

Important note:

Please save and reuse the Gotcha Holder and
GotchaClips for future projects.
®
The Gotcha is a registered trademark and GotchaClip is a trademark of
Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be
held liable for injury, loss or damage resulting from the use of these
products. Part #00INSGotchaClip/Pegboard
Incept-10.5.00
GotchaClips
Gotcha
for Pegboard
12G100
Instruction Sheet
Figure 1
Figure 2
Figure 3
35 Congress Street, Salem, MA 01970
Tel# 1- 800 631-9707 Fax# 1-800-560-2890
e-mail:signware@rosedisplays.com