ROSE DISPLAYS GOTCHA WITH ADHESIVE Manual

Advertisement

Gotcha with Adhesive

Parts

Installation Instructions

Step 1

Clean surface first. Be sure the surface that you
are applying the Gotcha with Adhesive to is dry
and free of dust.

Step 2

Place poster on a flat surface. Snap the Gotcha
open and insert poster. To close, snap the Gotcha
shut (Fig. 1). Note: It is easier to open and close the
Gotcha by starting at one end and working your way
down the holder.

Step 3

Peel paper backing off of adhesive (Fig. 2).

Step 4

Properly align Gotcha with Adhesive before
applying pressure. This procedure is very impor-
tant.

Step 5

To affix Gotcha with Adhesive, apply steady, firm
pressure for 15-30 seconds. Please allow adhe-
sive to cure for 30 minutes before changing
graphics.
The Gotcha
®
is a registered trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part #02INSGotcha withAdhesive
Rev. 7.31.02
Gotcha with Adhesive
Instruction Sheet
Figure 1
Peel paper
backing off
Figure 2
adhesive strip
35 Congress Street, Salem MA 01970
Tel# 1-800-631-9707 Fax# 1-800-560-2890
e-mail:signware@rosedisplays.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GOTCHA WITH ADHESIVE and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for ROSE DISPLAYS GOTCHA WITH ADHESIVE

  • Page 1 Gotcha with Adhesive Installation Instructions Step 1 Clean surface first. Be sure the surface that you are applying the Gotcha with Adhesive to is dry and free of dust. Step 2 Place poster on a flat surface. Snap the Gotcha open and insert poster.
  • Page 2 Gotcha with Adhesive Installation Instructions Step 1 Clean surface first. Be sure the surface that you are applying the Gotcha with Adhesive to is dry and free of dust. Step 2 Place poster on a flat surface. Snap the Gotcha open and insert poster.

Table of Contents