ROSE DISPLAYS ANOSKYBOX-TOP LOADING 3 WAY Manual

AnoSkybox™
Parts

Instructions for Assembly

Note:
We recommended that two people
assemble this AnoSkybox.

Step 1a

Slide spine into vertical rail.

Step 1b

Slide another vertical rail onto the
other edge of spine. Repeat for all
vertical rails and spines.

Step 2

Carefully insert corner brackets into
ends of bottom rails, using thumb as
shown in illustration. Two brackets
per end of each rail. Bracket can
bend if forced.
Detail- It is important that the corner
bracket tension tab faces toward
outside of frame. (2b)

Step 3

Lay out the bottom rails on the floor as
they will be configured.
The AnoSkybox™ is a trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part #03INAnoSkyboxTopLoad3Way
Incept-2.07.03
Top Load 3-Way Instruction Sheet
3
Spines with
pre-drilled holes Corner brackets
1a
2a
24
Single rails
2 3
3-Way
Page 1 of 2
9
Split rails
1b
2b
(Continued on other side)
35 Congress Street, Salem, MA 01970
Tel# 1- 800 631-9707 Fax# 1-800-560-2890
e-mail:signware@rosedisplays.com
6