ROSE DISPLAYS ANOGOTCHA SQUARE WITH MULTICLIPS Manual

AnoGotcha™

Parts

Instructions for Hanging

Step 1

Insert T-Top Gotcha Holder into AnoGotcha
Shell. Fig. 1

Step 2

Squeeze sides of MultiClip together. Fig. 2

Step 3

Align the bottom rail of the MultiClip with the
top channel of the aluminum holder. Slide
MultiClip into rail. Fig. 3

Step 4

Push end caps into place. Fig. 4

Step 5

Snap the AnoGotcha Holder open and insert
poster (top and bottom). Insert graphic completely
into holder until edge of graphic meets top of
holder. To close, snap the AnoGotcha Holder
shut. Fig. 5
Note: It is easier to open and close the Gotcha by
starting at one end and working your way down the
holder. With large or curling graphics, it may be
easier to insert graphic at one end and slide into
holder from one end to another

Step 6

Suspend poster. Fig. 6

Important note:

Please save and reuse the AnoGotcha Holder, End
Caps and MultiClips for future projects.
™
AnoGotcha is a trademark and Gotcha
Displays, Ltd. Neither the manufacturer nor any sales agent may be held
liable for injury, loss or damage resulting from the use
of these products. Part #02INSAnoGotchaSQMC
Incept-7.31.02
OneUp Instruction Sheet
AnoGotcha Shell
12AG400SQ
®
is a registered trademark of Rose
T-Top Gotcha
12GT100
Figure 1
Figure 3
Figure 5
MultiClip
1UP-0101
Figure 2
Figure 4
Figure 6
35 Congress Street, Salem, MA 01970
Tel# 1- 800 631-9707 Fax# 1-800-560-2890
e-mail:signware@rosedisplays.com
End Caps
06-5545