ROSE DISPLAYS ANOSCREEN WITH VARIO BASE Manual

AnoScreen™
Parts
Ano rails

Instructions For Assembly

Step 1

Insert corner brackets into ends of
bottom rails, using thumb, as shown
in illustration. 2 brackets per end of
each rail. Fig. 1
Detail Fig. 1a- Corner bracket tension
tabs face toward outside of frame.

Step 2

Snap base Ano rail sections into the
Vario base section.
Start at one end and work the Vario
base onto the Ano rail.

Step 3

Lay out parts as they will be configured
on the floor. (2, 3 or 4 panels)
The AnoScreen™ is a registered trademark of Rose Displays, Ltd. Neither
the manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part #02INAnoScreenVario.
Incept-8.15.02
Instruction Sheet
Vario Base Corner Brackets
1
2
3
3
Vertical Rails
with Flex Spine
1a
2a
3
2a
2 Panel
3 Panel
4 Panel
(continued on other side)
35 Congress Street, Salem, MA 01970
Tel# 1-800-631-9707 Fax# 1-800-560-2890
Split Rails
e-mail:signware@rosedisplays.com