AnoMulti™
Parts
Instructions for Hanging
Step 1
Insert the poster into the Slim Holder by either
sliding the poster into the holder or tapping the
holder onto the poster. . Fig. 1
Note: For thinner substrates, it may be neces-
sary to staple the edge of the graphic before
inserting into Slim Holder.
Step 2
Slide Slim holder into AnoMulti holder. Fig. 2
Step 3
Place cable onto inner channel of Cable Clip. The
cable should snap into place. Fig. 3
Step 4
Align one end of the Cable Clip with the top
channel of the aluminum holder. Then insert one
round end, then press down on the other round
end and slide Cable Clip into rail. Fig. 4
Step 5
Push end caps into place. Fig. 5
Step 6
Suspend poster. Fig. 6
Important note:
Please save and reuse the AnoMulti, Cable Clips,
End caps and MultiClips for future projects.
The AnoMulti™ and Slim™are trademarks of Rose Displays, Ltd.
Neither the manufacturer nor any sales agent may be held liable for
injury, loss or damage resulting from the use of these products.
Part #02INSAnoMultiSQCableClipSaucer
Incept-9.27.02
Instruction Sheet
AnoMulti
12AM300SQ
Cable Clips
06-5050
Figure 1
Figure 3
Figure 5
Cable and
End Cap
06-5545
16-0018SS
Figure 4
Figure 6
35 Congress Street, Salem, MA 01970
Tel# 1- 800 631-9707 Fax# 1-800-560-2890
e-mail:signware@rosedisplays.com
Saucer
Figure 2
Need help?
Do you have a question about the ANOMULTI SQUARE WITH CABLE CLIP AND CABLE AND SAUCER and is the answer not in the manual?
Questions and answers