AnoMulti™
Parts
Instructions for Hanging
Step 1
Insert the poster into the Slim Holder by either
sliding the poster into the holder or tapping the
holder onto the poster. . Fig. 1
Note: For thinner substrates, it may be necessary
to staple the edge of the graphic before inserting
into Slim Holder.
Step 2
Slide Slim holder into AnoMulti holder. Fig. 2
Step 3
Insert single ball of ball chain into inner channel of
Cable Clip. The cable should snap into place.
Fig. 3
Step 4
Align one round end of cable clip with top channel
of the aluminum rail and insert. Once in place,
insert end of ball chain into channel. Then press
down on the other round end of the cable clip and
slide into rail by pushing on the clip. Fig. 4
Note: Be sure to slide the ball chain into place by
pushing on the cable clip. Do not pull on, or
push against, the ball chain as this will cause it to
bind in the channel.
Step 5
Push end caps into place. Fig. 5
Step 6
Suspend poster. Fig. 6
The AnoMulti™ and Slim™are trademarks of Rose Displays, Ltd.
Neither the manufacturer nor any sales agent may be held liable for
injury, loss or damage resulting from the use of these products.
Part #02INSAnoMultiSQCableClipBallChain
Incept-7.4.02
Instruction Sheet
AnoMulti
12AM300SQ
Cable Clips
06-5050
Figure 1
Figure 3
Figure 5
End Caps
Ball Chains
06-5545
Figure 4
Figure 6
35 Congress Street, Salem, MA 01970
Tel# 1- 800 631-9707 Fax# 1-800-560-2890
e-mail:signware@rosedisplays.com
96-0302P
Figure 2
Need help?
Do you have a question about the ANOMULTI SQUARE WITH CABLE CLIP AND BALL CHAIN and is the answer not in the manual?
Questions and answers