ROSE DISPLAYS ANOGRIP WITH CABLE CLIPS Manual

AnoGrip™

Parts

Instructions for Hanging

Step 1

Place cable onto inner channel of Cable Clip. The
cable should snap into place. Fig. 1

Step 2

Align one end of the Cable Clip with the top
channel of the AnoGrip. Insert one round end, then
press down on the other round end and slide Cable
Clip into rail. Repeat for multiple Cable Clips.
Fig. 2 & 3
Note: If using one cable, place the Clip in the center of
the holder. For two cables, place each Clip 1/3 of the
way in from each end of the holder.

Step 3

Hold the anchor so that the Cable Clips are on top,
and insert graphic into slot. Slide graphic back and
forth lightly to make sure it is all the way in the
anchor. Fig. 4

Step 4

Suspend poster.

Instructions to remove graphic

Step 5

Slide graphic out side of anchor. Fig. 5

Important note:

Please save and reuse the AnoGrip, Cable Clips, and
Cable for future projects.
™
AnoGrip is a trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part #04INSAnoGripSS
Incept- 02.02.05
Instruction Sheet
Cable Clip
AnoGrip
12AW200
Cable and Saucer
06-5050
16-0018SS
Figure 1
Figure 3
35 Congress Street, Salem, MA 01970
Tel# 1- 800 631-9707 Fax# 1-800-560-2890
Figure 2
Figure 4
Figure 5
e-mail:signware@rosedisplays.com