ROSE DISPLAYS ANOCONNECTOR WITH ANOQUICK Manual

AnoConnector

Parts

Instructions for Hanging

Instructions for Hanging

Step 1

Push one AnoConnector into one end of first
AnoQuick rail. Be sure to start with single barb
side of the AnoConnector going into rail first.
Push in until it stops at the middle barb. Fig. 1
Note: The AnoConnector can also be used to
connect lengths of AnoGotcha and AnoMulti.

Step 2

Repeat with second AnoConnector going into
back slot of first AnoQuick rail. Fig. 2

Step 3

Push second AnoQuick holder onto first assembly.
Fig. 3

Important note:

It is very important to insert single barb side first.
The middle barb acts as a stop for the AnoQuick
rail.
TM
The AnoConnector is a trademark of Rose Displays, Ltd.
Neither the manufacturer nor any sales agent may be held
liable for injury, loss or damage resulting from the use of
these products.
Part #02INSAnoConnector
Incept-9.9.02
TM
Instruction Sheet
AnoQuick AnoConnectors
12A300 06-2930
Figure 1
Figure 2
Figure 3
35 Congress Street, Salem, MA 01970
Tel# 1- 800 631-9707 Fax# 1-800-560-2890
e-mail:signware@rosedisplays.com