Inlet Valves Dismantle; Inlet Valves - GAS GAS TXTPRO - 2009 Manual

The reed box assembly is composed of only one body, the
C
reeds and reed keepers. To inspect the assembly remove
it by removing the 4 screws (A) attaching it to the rear of
the left and right crankcases.
(A)
The distance between
reeds and the reed
keeper should be 6,5 mm
f o r a l l t y p e s
displacement models.
Reeds must be kept in perfect
conditions with no signs of nicks,
scratches, broken or folded sections.
Otherwise, the reed assembly must
be replaced with a new one.
-28-
Since this is the last
I
door of access to the
inside of the cylinder,
special precautions
must be taken to keep it in
good condition and to monitor
its performance periodically.
Cover the cylinder bore with
a clean shop towel to prevent
foreing material to enter the
compartment when handling
these parts.
o f
7