Registering Panel Control In A Timetable - Sharp PN-V601 Operation Manual

●Registering panel control in a timetable
1. Click the [Panel Control] tab.
A list of panel control commands will be displayed.
There are two categories: "Command Name" and "Input Source". Commands are as follows:
Command
Turn On Display *
1
Turn Off Display
Switch Input Source
(Input "No.")
TV *
2
*1 It cannot be used with the LB-46GX35 and LB-52GX35.
*2 It cannot be used with the SHARP LCD monitor (PN series) and the LB-1085.
• The commands supported by the panel (monitor)
can be checked with "Table of supporting panel
controls."
• To display "Table of supporting panel controls,"
click the button (
lower left of the panel control command list. Or, click
[About Panel Support] from [Help Menu].
The contents of "Table of supporting panel controls" are as follows:
Menu option
RC-232C
LAN
Turn On
Turn Off
Get Status
H/W Error Detection
Time Synchronization
Input "No."
TV
Turns the panel (monitor) power ON.
Puts the panel (monitor) into standby mode.
Switches the panel (monitor) input source.
Switch the input source of the panel (monitor) to "TV input". The channel at the
time of switching to the TV cannot be specified. The channel that was selected by
the TV immediately before switching is displayed.
) "About Panel Support" at the
Indicates the cable to be used for the connection (straight cable or cross cable).
Indicates transmission speeds supported.
Indicates whether LAN connection is supported.
Indicates whether the "Turn On Display" panel control command is supported.
Indicates whether the "Turn Off Display" panel control command is supported.
Indicates whether Get Status ( F p.101) is supported.
Indicates whether IDP hardware error detection is supported.
Indicates whether Time Synchronization ( F p.91, 92) is supported.
Indicates which input of the panel (monitor) is supported.
Indicates whether TV input is supported.
Timetable Editor
Creating a timetable
Description
Description
63