Other Connectors; Network Connectors; Usb Connector - Arcam AV888 Handbook

other
connectors
FM
AM
DAB
ETHERNET
Z1 IR
Z2 IR TRIG Z1
Z3 IR TRIG Z2
IR OUT TRIG Z3
data connectors
rLead/rdock
For use with an Arcam rLead or
SIRIUS FM
rDock accessory. See page 13 and
the accessory documentation for
AM
details.
RS232 serial connector
Use with control devices having
an RS232 serial port (for example,
DAB
Crestron and AMX touch screen
controllers). This connection
ETHERNET
is also used for upgrading the
Z1 IR
AVR500, AVR600 or AV888's
Z2 IR TRIG Z1
internal software.
USB
Z3 IR TRIG Z2
IR OUT TRIG Z3
888
ETHERNET
Z1 IR
Z2 IR TRIG Z1
Z3 IR TRIG Z2
IR OUT TRIG Z3

network connectors

This section deals with installation of the unit into an
existing home network. For information on how to use
the units network features, the USB socket, and for a list
of supported file types, refer to page 52.
Networking is a large subject and only the briefest
guidelines are presented in this handbook. Please
contact your Arcam dealer or specialist installer for
more information about introducing the AVR500,
AVR600 or AV888 into your computer network.
Ethernet
SIRIUS FM
If an Ethernet cable is connected, the unit will
automatically attempt to connect to your network.
AM
You should use CAT5 cable plugged into the RJ45 socket
labelled on the rear panel.
EThERnET
If your network uses static IP
addressing rather than DHCP,
you will need to provide any
DAB
gateway, DNS and proxy
information. See page 44 for
ETHERNET
Z1 IR
information on setting up the
network.
Z2 IR TRIG Z1
USB
Z3 IR TRIG Z2
IR OUT TRIG Z3
E-22
AM

USb connector

DAB
The AVR600 and AV888 (and the
ETHERNET AVR500 with the network option
Z1 IR
fitted) can play files stored on a
Z2 IR TRIG Z1 USB mass storage device, typically
a pen drive, but any USB device
USB
Z3 IR TRIG Z2
that complies with the 'mass
storage device' class is compatible.
IR OUT TRIG Z3
The unit only supports the direct
connection of USB devices
and will not support devices
connected through a hub. If regular access to the
uSB
socket is required, you may find it convenient to use a
USB extension lead.
See page 46 for details of supported file types.