Remote Control - Arcam AV888 Handbook

remote
control
The CR102 universal remote
controller
The CR102 is a sophisticated 'universal' backlit remote
control that can control up to eight devices. It is pre-
programmed for use with the AVR500, AVR600, AV888
and many other Arcam products (FM/DAB tuners, CD
players and DVD players).
With its extensive built-in library of codes, it can also
be used with thousands of third party audio-visual
components – TVs, satellite and set-top boxes, PVRs,
CD players, etc. See the list of codes at the back of this
handbook, beginning on page 64.
The CR102 is a 'learning' remote, so you can teach it
almost any function from an old single-device remote.
You can also program the CR102 to issue a sequence of
commands ('macros') from a single button press.
Using the remote control
Please keep in mind the following when using the

remote control:

Ensure there are no obstacles between the
<
remote control and the remote sensor on the
front panel. The remote has a range of about 7
metres. (If the remote sensor is obscured, the Z1
IR remote control input jack on the rear panel is
available. Please consult your dealer for further
information.)
Remote operation may become unreliable if
<
strong sunlight or fluorescent light is shining on
the remote sensor of the unit.
Replace the batteries when you notice a
<
reduction in the operating range of the remote
control.
1
2 3
6
4 5
7 8 9
PHONO RPT
0 TV
RND
TAPE
AV
AUX NET
iPOD
SHIFT MCH
SAT AV
DVD TUN
PVR VCR
AMP CD
OK
MODE
MENU
DISP
CH
DIRECT EQ EFFECT BASS
TRIM SYNC SUB TREBLE
SRCH
FAV+ FAVÐ HOME INFO
SETUP TITLE AUDIO SUBT
CR102
E-28
Inserting batteries into the
remote control
1. Open the battery compartment by pressing the
button on the back of the handset.
2. Insert four ' A AA' batteries into the battery
compartment – two facing the top of the unit,
and two facing the end, as in the diagram.
3. Lower the end cap onto the plastic locating plate
in the handset. This acts as a hinge, and you
can now push the end cap firmly into its locked
position with a click.
notes on batteries:
Incorrect use of batteries can result in hazards such
<
as leakage and bursting.
Do not mix old and new batteries together.
<
Do not use non-identical batteries together –
<
although they may look similar, different batteries
may have different voltages.
Ensure the plus (+) and minus (-) ends of each
<
battery match the indications in the battery
compartment.
Remove batteries from equipment that is not going
<
to be used for a month or more.
When disposing of used batteries, please comply
<
with governmental or local regulations that apply in
your country or area.