McAfee DR SOLOMON S ANTI-VIRUS 8.5 Administrator's Manual page 48

Installing Dr Solomon's Anti-Virus
15. At this point, you can:
48 Dr Solomon's Anti-Virus
Figure 2-10. Completing Setup panel
• Finish your installation. Leave the Scan Memory for Viruses
before Configuring checkbox clear, then click Skip Config to finish
your installation. Setup will ask if you want to start the WinGuard
scanner and the Dr Solomon's Anti-Virus Console immediately. To
do so, select the Start Dr Solomon's Anti-Virus checkbox, then
click Finish. Your Dr Solomon's Anti-Virus software is ready for
use.
NOTE: If you had a previous Dr Solomon's Anti-Virus version
installed on your computer, you must restart your system once
again in order to start the WinGuard scanner. Setup will
prompt you to restart your system.
• Choose configuration options for your installation. You can choose
to scan your system, create an emergency disk, or update your virus
definition files before you start the WinGuard scanner and the Dr
Solomon's Anti-Virus Console.
To do so, select the Scan Memory for Viruses before Configuring
checkbox to have Setup start the Dr Solomon's Anti-Virus
application briefly to check your system memory. Next, click
Configure.