Brother HL-1660e Series User Manual page 218

USER'S GUIDE
4–34
When the installed flash memory card or HDD card is formatted:
When you enter this mode menu with the formatted flash memory card or
HDD card installed, the display shows the following menus:
Display Message
EXECUTE DATA
CARD LIST
SAVE
DELETE
Note
A common use of the flash memory is with FORMS software packages.
With these commercially available software packages you have an option
to send a form to the printer without any data. After you send the form to
the printer, you may save the form in the flash memory as a Macro. Then
the next time you want to print this form, you would setup your FORMS
software package to SEND DATA ONLY - USE FORM IN PRINTER.
This process would save you anything from 1 to 4 minutes per print job.
Select the setting menu and enter the sub-setting menu to change the
settings as follows:
Execute Data
Note
This menu appears only when data has been saved on the card.
When you select "EXECUTE DATA," you can execute any of the data
saved in the SAVE DATA mode.
When you enter this sub-setting menu with the SET switch, the printer
prompts you to select the ID of the data.
DATA ID=#####
Select the ID with the
that the printer executes the selected data.
Flash Operation
Select the data ID and execute the selected
data. This menu appears only when any data
has been saved on the card.
Print out the contents of the flash memory
card or the HDD card. This menu appears
only when anything has been saved in the
card.
Save received data, macros, and fonts.
Delete items from the card.
or switch and press the SET switch again, so