Turning The Printer On And Off - Brother HL-1660e Series User Manual

Turning the Printer On and Off

Plugging in the Power Cord
Plug in the power cord as follows:
1. Make sure that the POWER switch is OFF "O": the switch is on the
front right hand side of the printer.
2. Attach the power cord to the printer and plug it into an appropriate
AC outlet.
!
Caution
Check the AC voltage. This printer should be operated at the specified
voltage and frequency.
Since this printer must be electrically grounded, the power cord
should be connected to a grounded AC outlet.
The total length of the power cord, including extension cords, should
not exceed 5 meters (16.4 feet). Use of a longer power cord may result
in reduced voltage or malfunctions.
Do not unplug the power cord to turn off the printer.
The printer should be installed near a power outlet which is easily
accessible.
Fig. 2-22 Plugging in the Power Cord
• USA and Canada:
• Europe and Australia:
CHAPTER 2 GETTING STARTED
AC 110 to 120 V, 60 Hz
AC 220 to 240 V, 50 Hz
2–19