Replacing Batteries; Get Started - Vitek VT-6401 BK Instruction Manual

Installation of batteries into remote sensor
1. Turn off the screws on the batteries compartment.
2. Select data transfer channel by channels switcher «1-2-».
. Install 2 batteries ("ААА", 1.5 V), following polarity.
4. Close battery compartment cover and turn up the screws.
Connecting AC-power adapter to basic block/ Installation of batteries
into basic block. Connect AC-power adapter (6,0V; DC) to basic block
through the jack for an external power source located below the batteries
compartment.
or
2. Open the cover of batteries compartment.
. Install three batteries ("AАА", 1.5 V), following polarity.
4. Close battery compartment cover.
Note:
Basic block is intended for power supply from external source, batteries are
used as reserve power source.

Replacing Batteries

On appearance of adequate icon indications displaying that the batteries are
down replace remote sensor batteries.

Get Started

By first startup, switch main block on, and switch on remote sensor. Set data
transfer channel by channel switcher «1-2-» located on remote sensor. Hold
button CHANNEL on main block, you will hear sound signal. Main block starts
searching remote sensor signal. Pres button Тх to reset the sensor. When con-
nection between sensor and main block is set on, temperature and humidity
indications from remote sensor will appear on LCD.
Setting pressure parameters by switching on the unit first time
1. After connecting basic block to power supply line pressure units' icon starts
blinking. Use buttons
mmHg.
2. Use buttons
PRESSURE for confirmation.
Setting pressure parameters via first startup is imperative for precise
weather forecast.
6401IM.indd 5
«▼/▲»to select pressure
Press button PRESSURE for confirmation.
«▼/▲» to set the value of altitude above sea level. Press button
units, inHg, hPa, mBar or
5
English
07.04.2008 12:35:47