Function Groups - EUTECH INSTRUMENTS ALPHA CON 1000 CONDUCTIVITY CONTROLLERTRANSMITTER Instruction Manual

Operating Instructions
4.2

Function Groups

The main function and sub-function groups are organised in a matrix format for configuration and
selection of parameters. The main function groups are:
1) Temperature Coefficient settings (
2) Temperature Measurement / compensation settings (
3) Control relay 1 configuration (
4) Control relay 2 configuration (
5) Control type ( Cntr Cntr
6) Current output (
7) Configuration (
ConF
8) Calibration ( CAL dO dO CAL
HOLD SETUP
tc tc
HOLD SETUP
CAL CAL
Con Con
The set-up parameters can be viewed or changed by entering a security code. See Section 5.2 for
security code information.
4.2.1 How to view operating parameters without access to change them:
000 000
S.Cd S.Cd
d) Press the ENTER key at a particular sub-function to view in detail.
e) Press the ENTER key to return to the sub-function menu.
f) Press the and
Measurement mode.
Note: To simplify operations, the controller will not display parameters that are not relevant to a
particular sub-function. For example: If the user set the controller for Limit control, it will not display
pulse length/frequency settings.
68X216802
tC tC
)
SP1 SP1
)
SP2 SP2
)
)
rng rng
)
ConF
)
HOLD SETUP
SEt SEt
HOLD SETUP
ConF ConF
a) Press the ENTER key. The display will prompt the user to enter a
security code (S.Cd). Leave the security code at "000" (do not enter a
security code).
b) Press ENTER key again. This allows you only to view (not
change) any sub-functions' settings.
c) Press the
keys simultaneously (as an Escape key) at any time to return to the
)
S S E E t t
HOLD SETUP
o o
C C
HOLD SETUP
or keys to scroll through the sub-functions.
o o
C C )
HOLD SETUP
SP SP 1 1
HOLD SETUP
rng rng
lpha-CON1000
SP2 SP2
Cntr Cntr
9