Configuration (Conf) Sub-Function - EUTECH INSTRUMENTS ALPHA CON 1000 CONDUCTIVITY CONTROLLERTRANSMITTER Instruction Manual

Press the ENTER key to confirm your selection.
8)
9) Press the ENTER key to return to Advanced Set-up mode, or return to Measurement mode by
pressing the
HOLD SETUP
COnf COnf
7.7

Configuration (ConF) sub-function

This group of parameters lets you configure the controller to suit your requirements.
7.7.1 Entering the Configuration sub-function
Enter Advanced Set-up mode. Push the ENTER key and scroll to Advanced Set-up security
1)
code "22". Push the ENTER key again.
Press the or
2)
7.7.2 Selecting the alarm time lag
This parameter group lets you select a period of time before the alarm activates when your set point has
been overshot. You can select from 0 to 1999 seconds.
HOLD SETUP
30 30
AL.d AL.d
Press the ENTER key to confirm your selection.
4)
5) Proceed to 7.9.3, or return to Measurement mode by pressing the
(escape).
7.7.3 Selecting steady or pulse contact for the alarm relay
This parameter group lets you select whether the alarm contact will operate as a steady contact or a
fleeting (single pulse) contact. Pulse contact closing time is 250 millisecond.
68X216802
and keys simultaneously (escape).
HOLD SETUP HOLD SETUP
0 0
ALd ALd
keys to scroll until the upper display shows "ConF".
Follow directions in 7.9.1 to enter Configuration mode.
1)
Press the ENTER key. Scroll with the
2)
upper display shows a numerical value (in seconds) and the lower
display shows "AL.d".
Press the
3)
to 1999 seconds) you want.
HOLD SETUP
Stdy Stdy
ALC ALC
or keys to select how long of an alarm delay (0
HOLD SETUP
0.0 0.0
L.Ad L.Ad
HOLD SETUP
no no
dEF dEF
or keys until the
and keys simultaneously
22