Function Groups; How To View Operating Parameters Without Access To Change Them - EUTECH INSTRUMENTS ALPHA CON 1000 CONDUCTIVITY CONTROLLERTRANSMITTER (REVISION 3) Instruction Manual

Operating Instructions
4.2

Function Groups

The main function and sub-function groups are organised in a matrix format for configuration and
selection of parameters. The main function groups are:
1) Temperature Coefficient settings (
2) Temperature Measurement / compensation settings (
3) Control relay 1 configuration (
4) Control relay 2 configuration (
5) Control type (
Cntr
6) Current output (
7) Configuration (
ConF
8) Calibration (
CAL Con
HOLD SETUP
HOLD SETUP
Cal
C
The set-up parameters can be viewed or changed by entering a security code. See Section 5.2 for
security code information.
4.2.1

How to view operating parameters without access to change them:

a) Press the ENTER key. The display will prompt the user to enter
a security code (S.Cd). Leave the security code at "000" (do not
enter a security code).
b) Press ENTER key again. This allows you only to view (not
change) any sub-functions' settings.
c) Press the ▲ or ▼ keys to scroll through the sub-functions.
d) Press the ENTER key at a particular sub-function to view in
detail.
e) Press the ENTER key to return to the sub-function menu.
f) Press the ▲ or ▼ keys simultaneously (as an Escape key) at any time to return to the
Measurement mode.
Note: To simplify operations, the controller will not display parameters that are not relevant to a
particular sub-function. For example: If the user set the controller for Limit control, it will not display
pulse length/frequency settings.
). See Section 7.1.
tc
). See Section 7.3.
SP1
). See Section 7.3.
SP2
). See Section 7.4.
). See Sections 7.5 & 7.6.
rng
). See Section 7.7.
). See Sections 6 & 7.8.
HOLD SETUP
°C
HOLD SETUP
o
). See Section 7.2.
SEt C
HOLD SETUP
Sp1
HOLD SETUP
6
αlpha-CON1000
HOLD SETUP
Sp2
HOLD SETUP
000