Epson C32C824151 - UB E02 Print Server Technical Reference Manual page 20

3. Tighten the screws.
If you have removed an interface circuit board that was already installed, fix the UB-E02
using the removed screws.
4. Plug the twist pair cable into the 10BASE-T/100BASE-TX Ethernet connector of the UB-E02
until it clicks.
CAUTION:
Be sure not to connect a telephone line, display module connector, or drawer kick-out
connector cable to the 10BASE-T/100BASE-TX Ethernet connector of the UB-E02.
The display module connector on the TM printer cannot be used when the UB-E02 is
installed.
5. Connect the power unit to the printer.
6. Turn on the printer power.
Note:
When initializing the UB-E02 by turning off the power and then turning it back on or by resetting the
printer, there is a waiting time until the network starts operating. During this time, all the
communicating functions of the network do not work.
The waiting time is:
When the IP address setting is Manual (Fixed): approximately 6 seconds
When the IP address setting is Auto:
2-4 Installation
approximately 13 seconds
(It can be longer, depending on the reply time of
the host.)
Rev. A