Table of Contents
Advertisement
Safety Precautions
This section presents important information to ensure safe and effective use of this product.
Please read this section carefully and store it in an accessible location.
CAUTION:
Be careful to avoid dropping conductive objects such as paper clips on the circuit
board, as they could short circuit connections and cause damage from excessive
current.
This product should only be connected to the devices specified in this guide.
Connecting other devices could cause damage, fire or explosion.
Never disassemble or modify this product. Tampering with this product may result in
injury, fire, or electric shock.
Be sure to set the product on a firm, stable, horizontal surface. The product may
break or cause injury if it falls.
Never connect a public telephone line to the modular connector on this product.
Do not use in locations subject to high temperature, humidity or dust levels.
Excessive temperature, humidity or dust may cause equipment damage, fire, or
shock.
Parts on the circuit board may become hot during operation. Therefore, wait
approximately 10 minutes after turning the power off before touching them.
To prevent the possibility of electrical shock, do not perform installation or connect
cables during a thunderstorm.
Label
A caution label like the one is attached near the display module connector of the TM printers.
The label has the following meaning:
"The display module connector and the drawer kick-out connector use the same type of
Ethernet connector; therefore, be sure not to connect the Ethernet connector cable or the
telephone line to the display module connector or the drawer kick-out connector."
Product Servicing
This product cannot be serviced at the component level. If damage occurs, the UB-E02 should be
replaced as a unit.
vi
Rev. A
Advertisement
Table of Contents
