Ub-E02 Installation - Epson C32C824151 - UB E02 Print Server Technical Reference Manual

2.5 UB-E02 Installation

CAUTION:
Before installing the UB-E02, be sure to set the DIP switches or Memory switches as shown
in the table below. For other models, please ask your dealer.
Model
TM-U200 Series
TM-U210 Series
TM-U230 Series
TM-U325 Series
TM-U590 Series
TM-U675 Series
TM-T88/T88II/T88III
TM-T90
TM-H5000/H5000II
TM-H6000/H6000II
TM-J7000/J7100
TM-J7500/J7600
TM-J2000/J2100
TM-L90
Be sure to disconnect the power supply of the printer (in addition to turning off the
power switch) .Even when the power switch is turned off, some of the internal circuit
board has electricity. If you install or remove the UB-E02 with the power supply
connected, the UB-E02 and the printer may be damaged.
1. Be sure that the power for the printer and host computer is turned off.
2. Install the UB-E02 in the printer.
If an interface circuit board is already installed, remove it and install the UB-E02.
remove screw
Rev. A
Setting
DIP SW 2-8: ON
DIP SW 2-8: ON
DIP SW 2-8: ON
DIP SW 2-8: ON
DIP SW 2-8: ON
DIP SW 2-8: ON
DIP SW 2-8: ON
MSW 1-8: ON
DIP SW 2-8: ON
DIP SW 2-8: ON
MSW 1-8: ON
MSW 1-8: ON
MSW 1-8: ON
MSW 1-8: ON
UB-E02 Technical Reference Guide
remove screw
Installation 2-3