Unavailable Functions After Upgrading - Denon AVR-3310CI Owner's Manual

ENGLISH

Unavailable Functions After Upgrading

When upgrading, the RS-232C connector cannot be used for the DENON RF remote controller.
Connecting Devices
External Controller
vpage 22 of GThe original versionH Operating Instructions
n RS-232C connector
When you connect an external control device, you can control the AVR-3310CI
with the external control device. Perform the operation below beforehand.
q Turn on the AVR-3310CI's power.
w T urn off the AVR-3310CI's power from the external controller.
e Check that the AVR-3310CI is in the standby mode.
Set as Necessary
Set this to use the RS-232C connector for the DENON RF remote controller.
"232C Port"
When using the AVR-3310CI in combination with the DENON RF remote controller (RC-7000CI, sold
separately) or RF remote receiver (RC-7001RCI, sold separately), two-way communication is enabled.
The AVR-3310CI's status information as well as iPod and Internet audio music files can be browsed
watching the RF Remote Controller's display. For details, refer to the operating instructions of the
respective devices.
NOTE
On the GUI menu, when setting "232C Port" to "2Way Remote", you cannot use the RS-232C
connector as an external controller.

When upgrading, the DENON
RF remote controller cannot be
connected.
Making Detailed Settings
(Manual Setup)
Making Other Settings (Option Setup)
OPTION
vpage 43 of GThe original versionH Operating Instructions
When upgrading, this setting cannot be selected.
Setting items
232C Port
Serial Control : Set when using an external controller.
2Way Remote : Set when using a 2-way remote control unit.
Set when using an external
controller or two-way remote
W hen using a DENON two-way remote control (RC-7000CI or RC-
control connected to the RS-
7001RCI, sold separately), set to "2Way Remote".
232C terminal.
NOTE
When setting to "2Way Remote", you can not use the RS-232C connector
as an external controller.
Setting contents