Denon AVR-3310CI Owner's Manual page 8

ENGLISH
Make the Optimal Speaker Settings, and Correct the Room Acoustics (Audyssey™ Auto Setup)
NOTE
• Loud test sounds may be played during Audyssey MultEQ ®
automatic speaker setup. This is part of normal operation. If there
is background noise in room, these test signals will increase in
volume.
• Do not stand between the speakers and setup microphone or allow
obstacles in the path while the measurements are being made. This
will cause inaccurate readings.
• Make the room as quiet as possible. Background noise can disrupt
the room measurements. Close windows, silence cell phones,
televisions, radios, air conditioners, fluorescent lights, home
appliances, light dimmers, or other devices as measurements may
be affected by these sounds.
Cell phones should be placed away from all audio electronics during
the measurement process as Radio Frequency Interference (RFI)
may cause measurement disruptions (even if the cell phone is not in
use).
MASTER VOLUME
• Operating during the measurements will cancel
the measurements.

Main remote control
operation buttons
a Connect the Included Setup
Microphone
vpage 29 of GThe original versionH Operating Instructions
s Audyssey Auto Setup Preparations
STEP1 Preparation
Perform the following settings if adjustments, etc., are required for
the speaker environment you're using.
If you do not need to perform the following settings, or have already
completed them, select "Auto Setup Start" and then press
Proceed to " STEP2 ".
Change the Amplifier Assignment (Amp Assign)
The signal output from the SURR.BACK/AMP ASSIGN speaker
terminal of the AVR-3310CI can be switched to match your speaker
environment (vpage 8 "Amp Assign").
1
Press to select
ui
"Amp Assign", then
press ENTER .
:Displaying the menu :Moves the cursor
Cancel the menu (Up/Down/Left/Right)
around items indicate the default setting.
ENTER
.
:Confirm the setting
2
Press to select Amp Assign Mode, then press
o p
RETURN
.
Normal : T he surround back channel audio signals are
output.
ZONE2 : The ZONE2 audio signals are output.
: The ZONE3 audio signals are output.
ZONE3
ZONE2/3-MONO : T he ZONE2 / ZONE3 monaural audio signals are
output.
: T he bi-amp audio signals are output. Set this for
Front A Bi-Amp
bi-amp playback of the front A speakers.
: T he bi-amp audio signals are output. Set this for
Front B Bi-Amp
bi-amp playback of the front B speakers.
: T he front height channel audio signals are output.
Front Height
Front Wide : T he front wide channel audio signals are output.
indicates functions added by upgrading.
• When you are using surround back speakers with ZONE2/ZONE3,
set to "ZONE2" or "ZONE3".
• You can set in the same way as described in "Amp Assign" on page
8.
NOTE
Since "Amp Assign" of AVR-3310CI is set to "ZONE2" by default,
audio is not output from the surround back speakers. When using the
surround back speakers with MAIN ZONE, change the "Amp Assign"
setting to "Normal".
Set the channel to be measured (Channel Select)
vpage 30 of GThe original versionH Operating Instructions
d Perform Audyssey Auto Setup
vpage 30 of GThe original versionH Operating Instructions
:Return to previous menu