Table of Contents
Advertisement
Rotary Cutter
•
The Rotary Cutting Head is rated to cut
vegetation up to 5" in diameter.
•
Objects tend to be thrown out from under the
head in the direction of blade rotation and
toward the raised edge of the shroud. Avoid
cutting with the head tilted at an angle that
objects would be thrown towards the unit
operator position.
•
When clearing brush and small trees, operate
unit at 1 mph ground speed and position cutter
head at an angle that will cut 2' to 3' into the
growth. Make the first pass just above ground
level. This will remove the low branches and
allow operator a better view of the material to
plan for the next pass. After repeated passes,
each elevated approximatly 4' above the last, the main trunks of the trees will be exposed and they can be
cut as desired. This avoids clogging the head with cut and mulched material.
•
Open the hydraulically operated door to allow blades to reach large diameter vegetation. Operate the
mower with the door closed when cutting grass, weeds, and light brush to reduce thrown objects for safer
mower operation.
•
When operating near the ground or when mulching be particularly careful that there are no bystanders or
animals with a 100 yards. Debri tends to fly out at great speed and can injure or even cause death.
OPS-B- 0039
The rotating parts of this machine have been designed and tested for rugged use.
However, the blades could fail upon impact with heavy, solid objects such as metal guard
rails and concrete structures. Such impact could cause the broken objects to be thrown
outward at very high velocities. To reduce the possibility of property damage, serious
injury, or even death, never allow the cutting blades to contact such obstacles.
All Safety Shields, Guards and Safety devices including (but not
limited to) - the Deflectors, Chain Guards, Steel Guards, Gearbox
Shields, PTO integral shields, and Retractable Door Shields should
be used and maintained in good working condition.
devices should be inspected carefully at least daily for missing or
broken components.
replaced at once to reduce the possibility of injury or death from
thrown objects, entanglement, or blade contact.
Many varied objects, such as wire, cable, rope, or chains, can become entangled in the
operating parts of the mower head. These items could then swing outside the housing at
greater velocities than the blades. Such a situation is extremely hazardous and could result
in serious injury or even death. Inspect the cutting area for such objects before mowing.
Remove any like object from the site. Never allow the cutting blades to contact such items.
(SGM-06)
AXTREME 2 02/10
© 2010 Alamo Group
OPERATION
Missing, broken, or
worn items must be
Operation Section 3-42
All safety
(SGM-3)
(SGM-4)
Advertisement
Table of Contents
