1.4. Features
Allows control and monitoring of multiple UPSs via LAN and INTERNET
Real-time dynamic graphs of UPS data (voltage, frequency, load level, battery
capacity)
Safely OS shutdown and protection from data loss during power failure
Warning notifications via audible alarm, pop-up screen, broadcast, mobile
messenger, and e-mail
Scheduled UPS on/off, battery test, programmable outlet control, and audible
alarm control
Password security protection and remote access management
2. ViewPower Install, Quick Start, and Uninstall
2.1. System Requirement
256 MB physical memory at least (512 MB is recommended)
200MB hard disk space at least
Administrator authority is required
More than 16-bit colors and 800 x 600 or above resolution display is
recommended
TCP/IP protocol must be installed for network management
An available communication port (RS232 serial port or USB port) is needed
Platforms supported by software are listed below:
Windows 2000
Windows 2003
Windows XP
Windows VISTA
Windows 2008(32-bit & x64-bit)
Windows 7(32-bit & x64-bit)
RedHat Linux 8 and above
RedHat Enterprise AS3 and above
3