Access Ports - GE HOME GENERATOR 10000 WATT Operator's Manual

Access Ports

The home generator is equipped with several access
openings and a removable roof to permit simple oil and
filter servicing.
To remove roof:
Remove the four screws and lift off. Replace roof in
reverse order.
To remove access cover:
Remove the two screws, tilt cover out, and lift cover off
panel. Replace cover in reverse order.
To remove side panel (if necessary):
1. Remove roof.
2. Remove screw(s) attaching side panel.
WARNING Contact with muffler and engine parts can result in
serious burns.
• DO NOT touch hot parts and AVOID hot exhaust gases.
• Allow equipment to cool before touching.
3. Pull panel outward (away) from unit while pulling
panel upward and out of base.
To install side panel:
1. Guide bottom of side into base.
2. Push panel until it is flush with sides.
3. Replace panel screw(s).
4. Replace roof and screws.
Each home generator is suppied with a set of identical keys.
These keys fit the locks that secure the access door.
To open access door:
1. Insert key into lock of access door and turn key one
quarter turn counterclockwise.
2. Grasp door's handle and turn one quarter turn
counterclockwise to open. Remove key.
To close access door:
1. Close door and turn doors handle one quarter
turn clockwise.
2. Insert key into lock of access door and turn key one
quarter turn clockwise. Remove key.
13