Set Active Effect By Id (Mc-12, Mc-1); Set Record Input (Mc-12, Mc-1) - Lexicon MC-12 V2.0 - SERIAL COMMUNICATIONS PROTOCOL DEFINITION REV 1-3 Manual

Lexicon, Inc.
MC-12 Serial Communications Protocol
The MC-12 will assign the value from the packet to the front/back balance.
7.3.20.4 Data Validation
If a value is passed that exceeds the maximum value of that parameter the MC-12 will ignore the command
and transmit a NAK command with an error code DC_INVALID_DATA.

7.3.21 Set Active Effect by Id (MC-12, MC-1)

This command requests the MC-12 to set the active effect to the value in this packet.
This command has been maintained for backward compatibility with MC-1. In order to maintain backward
compatibility, the MC-12 Parameters have been mapped to the MC-1 parameters as described in each Data
Description. MC-12 users should be using the command described in
(MC12_Set_Active_Effect_By_Id).
7.3.21.1 Command Packet Description
Application Header:
Command
Data Count
Application Data:
Data[0]
7.3.21.2 Data Description
EffectId:
Data Type:
Definition/Conversion:
7.3.21.3 MC-12 Response
The MC-12 will load the desired effect.
7.3.21.4 Data Validation
If a value is passed that exceeds the maximum value of that parameter the MC-12 will ignore the command
and transmit a NAK command with an error code DC_INVALID_DATA.

7.3.22 Set Record Input (MC-12, MC-1)

Sets the Record input.
This command has been maintained for backward compatibility with MC-1. In order to maintain backward
compatibility, the MC-12 Parameters have been mapped to the MC-1 parameters as described in each Data
Description. MC-12 users should be using the command described in
7.3.22.1 Command Packet Description
© 2002 Lexicon, Inc. All rights reserved.
DC_CMD_SET_EFFECT
1
EffectId
Unsigned 8 bit integer
Appendix I MC-1 to MC-12 Effect ID
Printed on: 10/10/02
7.3.50
0x24
0x01
nn
Map.
7.3.51 (MC12_Set_Record_Input).
25 of 92