Lexicon LXP-15-II Owner's Manual page 74

Two LXP-15 IIs can be slaved together by connecting a cable from the MIDI OUT
jack of the master to the MIDI IN jack of the slave. Additional LXP-15 IIs can be
slaved to the master by connecting a cable from the MIDI THRU port of one slave
unit to the MIDI IN port of the next unit. All of the LXP-15 IIs must be set to the
same MIDI channel.
INPUT OUTPUT HEADROOM
OVL
12
exicon
18
24
When connected in this way, the slave LXP-15 II(s) will be remotely controlled
by the front panel of the master as follows:
• In general, whenever the master's ADJUST knob is used to change a
parameter value, a corresponding parameter change will occur on the
slave(s).
• Loading presets or registers from the setup page in either the "Preset" or
"Register" modes will cause the slave(s) to load their preset or register of the
same number . (Note: a slave's register contents will not necessarily be the
same as the master's.)
• Loading presets or registers in either the "PreScan" or "RegScan" modes will
cause the slave(s) to select the preset and register of the same number . The
"Load" button of the slave must be pressed to actually load the preset or
register.
• Changes made on the "Store" page are not transmitted to the slave(s).
Patches can also be created using LXP-15 II MIDI System Exclusive data. This
is perhaps the most complicated but also the most flexible way of creating
patches to control the LXP-15 II.
Chapter 7 provides the information necessary for programming LXP-15 II MIDI
SysEx data.
MIDI Out
ADJUST PAGE
Reverb
Level
Pitch/EQ
Mod
Dly
Alg
Setup
Patch 1
Store
Patch 2
Name
Patch 3
VIEW
Global
Patch 4
MIDI
Sys
Master
INPUT
exicon
POWER
LXP-15
OUTPUT HEADROOM
OVL
12
18
24
Slave
MIDI Operation
Slaving two or more
LXP-15 IIs
MIDI In
ADJUST PAGE POWER
Reverb
Level
Pitch/EQ
Mod
Dly
Alg
Setup
Patch 1
LXP-15
Store
Patch 2
Name Patch 3
VIEW Global
Patch 4
MIDI
Sys
Creating Patches using
MIDI SysEx
6-3