Lexicon LXP-15-II Owner's Manual page 26

LXP-15 II Owner's Manual
3-2
The routing and mixing of input and output signals for all algorithms are
controlled by the five parameters found on the "Level" page. As these parame-
ters are common to all LXP-15 II algorithms, they are described first. The
algorithm-specific parameters will be described with each algorithm.
InLevl Mix
0-100% 0-100%
Input Level: Adjusts the amount of input signal sent into the effects algorithm.
This signal is the sum of the left and right inputs, after the front-panel input
control.
Mix: Adjusts the mixture of the dry (left and right inputs) and wet (the left and right
algorithm outputs) signals sent to the left and right outputs. When set to 0%, only
dry signal is present at the outputs. When set to 100%, only wet signal is present
at the outputs.
Dry Pan: A pan control for the dry signal. When a mono input source is used, Dry
Pan will "move" the sound between the left and right speakers. When a stereo,
or two-channel input source is used, Dry Pan will make one channel louder as
the other gets softer.
Wet Pan: A pan control for the wet signal. All effects in the LXP-15 II are mono-
in/stereo-out. Wet Pan will make one effects channel louder as the other gets
softer.
Output Level: Adjusts the amount of dry/wet mix sent to the front panel output
control.
LEVEL
Wet Pan Dry Pan
100%L-51%L, 100%R-51%R,
Center, Center,
51%R-100%R 51%R-100%R
Lexicon
OutLevl
0-100%