Client Setup - D-Link DCS-7110 User Manual

Configuration

Client Setup

Click on the Client Settings button to bring you to the following screen which
allows you to configure the basic protocol options for you camera.
H.264/MPEG4 Protocol Options
For additional information about streaming options please refer to page 31.
UDP Unicast: Stream to a single computer.
UDP Multicast: Stream to multiple computers.
TCP: Provides higher quality video streaming than UDP and provides error correction.
However, transmission speed will be reduced.
HTTP: Offers the highest image and video quality. However, packet loss will diminish
image quality when bandwidth becomes restricted. If the network is protected by
a firewall and it opens only HTTP port (80), HTTP protocol must be selected. In this
mode, audio is disabled and only video can be viewed. UDP connections will not be
available to remote users if all four ports have not been forwarded. Only the HTTP
port must be forwarded for remote users to make an HTTP connection (video only).
MP4 Saving Options
Folder: Select the folder where you would like the MP4 file saved on your computer.
File name prefix: Enter a file name prefix for the MP4 files.
Add date and time suffix to file name: Select this checkbox if you would like the
date and time to be added to the end of each filename.
Local Streaming Buffer Time
Enter the buffer time in milliseconds. The buffer will cause a slight delay between live
activity and the video of the live stream but may increase the quality of video.
D-Link DCS-7110 User Manual 24