D-Link DCS-7110 User Manual page 43

Configuration
• Refresh: Click this button to refresh all current connections.
• Add to deny list: You can select entries from the Connection Status list and add them to the
Deny List to deny access. Please note that the selected connections will only be disconnected
temporarily and will automatically try to re-link again (IE Explore or Quick Time Player). If you
want to enable the denied list, please select Enable access list filtering and click Save in the
first column.
Disconnect: If you want to break off the current connections, please select them and click this
button. Please note that those selected connections will only be disconnected temporarily and will
automatically try to re-link again (IE Explore or Quick Time Player).
Enable Access List Filtering: Select this item and click Save if you want to enable the access list
filtering function.
Filter Type
Select Allow or Deny as the filter type. If you choose Allow Type, only those clients whose IP addresses
are on the Access List below can access the camera, and the others cannot access. On the contrary,
if you choose Deny Type, those clients whose IP addresses are on the Access List below will not be
allowed to access the camera, and the others can access.
Filter
Then you can add a rule to the following Access List. Please note that the IPv6 access list column
will not be displayed unless you enable IPv6 on the Network page. For more information about IPv6
Setting, please refer to Enable IPv6 for detailed information.
There are three types of rules:
Single: This rule allows the user to add an IP address to the Allowed/Denied list.
Network: This rule allows the user to assign a network address and corresponding subnet mask to
the Allow/Deny List.
Range: This rule allows the user to assign a range of IP addresses to the Allow/Deny List (This rule
is only applied to IPv4).
Administrator IP address
Always allow the IP address to access this device: You can select this item and add the Administrator's
IP address in this field to make sure the Administrator can always connect to the device.
D-Link DCS-7110 User Manual 43