Compaq 230050-001 - StorageWorks NAS B3000 Model N900 Server Rack Installation Instructions page 7

6
1 1
1 3
4
1
b. Secure the outer bracket rail to the rack-mounting bracket
with an 8-32 x 1/4-inch slotted screw.
IMPORTANT Do not tighten screws until all three screws have been lined up on
the assembly. Do not use nuts or washers with the screws.
c. Adjust the inner slide to access screw holes through the
slotted opening of the inner slide.
d. Fasten the bracket rail to the rack-mounting bracket as
shown.
e. Repeat this procedure for the left rack-mounting bracket
assembly.
Replace the server rail by aligning it with the front mounting
bracket and sliding forward until you hear a click. Press the
7
latch in and slide the server rail through the jacket assembly
until it stops.
Mark the front and back of the rack using the server rack
template.
2
1
2
8
Insert the cage nuts into the rack rails and use the fitting tool to
pry the cage nut into position.
9
Secure the back of the rack-mounting bracket to the rack using
M6 x 12 mm Phillips head screws.
10
Secure the front of the rack-mounting bracket to the rack using
M6 x 12 mm Phillips head screws.
CZR4-012.eps