Regulatory Compliance Notices; Connecting The Power Source - Compaq 230050-001 - StorageWorks NAS B3000 Model N900 Server Rack Installation Instructions

8
The NAS B3000 connection process is complete.

Connecting the Power Source

Connect each power supply to a separate power source. If
multiple uninterruptible power supplies are available, use them.
1. Connect the power cords from the storage enclosure to a
power source.
2. Connect the power cord from the Remote Insight Lights-Out
Edition board to a power source.
3. Connect the power cords from the device to a power source.
CAUTION: To reduce the risk of equipment damage, do not power
up at this time.
CAUTION: To reduce the risk of data loss, do not disconnect the
power cord from the storage enclosure while the device is running.
The power source connection process is complete.
For instructions on configuring the system, refer to the
StorageWorks NAS B3000 by Compaq Quick Reference poster.

Regulatory Compliance Notices

European Union Notice
Products with the CE Mark comply with both the EMC
Directive (89/336/EEC) and the Low Voltage Directive (73/23/
EEC) issued by the Commission of the European Community.
Compliance with these directives implies conformity to the
following European Norms (the equivalent international
standards are in parentheses):
·
EN 55022 (CISPR22) Electromagnetic Interference
·
EN 50082-1 (IEC 801-2, IEC 801-3, IEC801-4)
Electromagnetic Immunity
·
EN 60950 (IEC 950) Product Safety
Federal Communications Commission Notice
The rating label on the device shows which class (A or B) the
equipment falls into.
Class B devices have a FCC logo or FCC ID on the label. Class
A devices do not have a FCC ID or logo on the label. After the
class of the device is determined, refer to the following
corresponding statement. For complete details, see the Hardware
Reference Guide on the device Documentation CD.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules and Regulations. These limits are designed to
provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in
accordance with instructions, may cause harmful interference
that will occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or
more of the following measures:
·
Reorient or relocate the receiving antenna.
·
Increase the separation between the equipment and receiver.
·
Connect the equipment to an outlet on a circuit different
from that to which the receiver is connected.
·
Consult the dealer, or an experienced radio or television
technician for help.
Modifications
The FCC requires the user to be notified that any changes or
modifications made to this device that are not expressly
approved by Compaq Computer Corporation may void the
user's authority to operate the equipment.