Compaq 230050-001 - StorageWorks NAS B3000 Model N900 Server Rack Installation Instructions page 3

Installing the Storage Enclosure
into the Rack
1 1
5
Identify the storage enclosure rack-mounting hardware.
Item Description
Left rack-mounting bracket
Right rack-mounting bracket
Rack template
Side flange bracket
Screws, washers, clips, and nuts
2
T E M
With a pencil, mark the front and back of the rack using the
storage enclosure rack template as a guide. Then, if the rack has
square holes, complete steps 4, 5, and 7. If the rack has round
holes, complete steps 3, 6, and 8.
3
4
P L A T
E
3
1
2
For round-hole rail racks only:
a. Secure two alignment clips
mounting bracket.
b. Secure one alignment clip
mounting bracket.
4
For racks with square holes, install two side flange brackets on
the inner vertical rails for each rack-mounting bracket.
a. Using the center inner vertical U-rail section to position the
rack-mounting bracket, position a side flange bracket on the
left rack-front rail, then secure the bracket using a hex-head
self-tapping screw.
b. Install a U-nut on a side flange bracket.
c. Using the bottom inner vertical U-rail section to position the
rack-mounting bracket, position the side flange bracket
(from previous step) on the left rack-rear rail, then secure the
bracket using a hex-head self-tapping screw.
2
on the front of each rack-
on the rear of each rack-
1
2