Using Nokia Network Voyager - Nokia IP390 - Security Appliance Installation Manual

If the Hostname? prompt does not appear on the console, check the console port and console
display connections to ensure that the serial cable is completely plugged in at both ends. If
you verify the console connections and still do not see either the BOOTMGR> or
Hostname? prompts, verify that the terminal or terminal emulator program settings are
correct. If the settings are correct, contact your Nokia service provider as listed in
Contact Information"
3. Respond to the Hostname? prompt within 30 seconds to prevent the DHCP client from
starting.
If the DHCP client starts, it might configure the appliance with an incorrect host name and
IP address (this could happen if a DHCP server on your network is configured to respond to
any request). To reset the incorrect host name and IP address:
a. Establish a console connection to the appliance.
b. Log into the system using the user name admin and the password password.
c. Enter the following:
d. Reboot the appliance.
e. Respond to the Hostname? prompt within 30 seconds to prevent the DHCP client from
4. At each subsequent prompt, type the requested configuration information and then press
Enter.
For more information about how to respond to the prompts during the initial configuration
process, see the Getting Started Guide and Release Notes for the version of Nokia IPSO you
are using.
5. After you complete the initial configuration, you can use Network Voyager to configure the
remaining network ports.

Using Nokia Network Voyager

Use Nokia Network Voyager to configure and monitor your appliance. For additional
information about how to use Network Voyager, see
Using Nokia Network Voyager"
To open Nokia Network Voyager
1. Open a Web browser on the host you plan to use to configure or monitor your appliance.
2. In the Location or Address field, enter the IP address of the initial interface you configured
for the appliance.
You are prompted to enter the admin username and the password you entered when you
performed the initial configuration.
IP390 Security Platform Installation Guide
on page 3.
rm /config/active
or
mv /config/active /config/active.old
restarting.
"Viewing Nokia IPSO Documentation by
later in this section.
Using Nokia Network Voyager
"Nokia
33