Dual Delays - Lexicon 960L V2.5 - ADDENDUM Owner's Manual Addendum

960L

DUAL DELAYS

The Dual Delay algorithm is similar to Simple Delay, except
with two delay lines for each input channel. Each voice
has independent delay time, output level, feedback
control, filtering, and panning. The feedback path also
features high-pass and low-pass filters. Each voice has up
to two seconds of delay time.
In addition to the basic voice architecture described
above, Dual Delay provides more control over diffusion.
This is explained in the parameter section.
Parameters
Please refer to the parameter section for Simple Delay.
This section will only describe parameters not introduced
earlier.
Version 2.5 Software Release
General Parameters
FbkMST Controls the level of all feedbacks AND
crossfeeds.
Grain Provides further control of the input diffusor. A
low value causes a very tight smear pattern
(perhaps only discernable on percussion). A
large value causes a more spread-out
pattern.
FbkDiff Provides diffusion in the feedback path. It
creates the effect of moving echoes a little
farther into the background as they loop,
which is useful when modeling tape loops
and other effects.
Fgrain Controls gain for the feedback diffusor.
Delay Voice Parameters
Xfd Adjusts crossfeed control from positive full
scale to negative full scale. This injects the
delay signal into the opposite delay line. It
can be used to create ping-ponging effects
or to cause density buildup. A voice can be
crossfed even if its gain is OFF. Be aware of
the position of FbkMST when making Xfd
adjustments.
Tip:
To reset the parameter to OFF, hold down the
FINE ADJ key and touch the fader lightly.
3