Lexicon 12T User Manual page 49

Destination
<Clear All>
MMIO_Analog_In L & R
MMIO_SPDIF_In L & R
MMIO_TOSLINK_In 1 - 8
12T_Analog_Out L & R
12T_SPDIF_Out L & R
12T_TOSLINK_Out 1 - 8
The following diagram shows a flow chart of the audio routing from the picture of the control panel
above. Note that the PC-90 receives its input from the MMIO application via the
MMIO_Analog_Out_L and MMIO_Analog_Out_R sources. These sources route any
audio assigned to the analog outs into the PC-90.
Note also that, as 12T_Analog_Out_L and 12T_Analog_Out_R are selected as PC-90s
destinations, the audio is summed with the outputs of the audio application, which should also
routed to the analog outputs. This allows monitoring of PC-90 reverb and all audio from your audio
software through the same outputs of the interface.
Description
Clears all destination assignments
Sends the PC-90 out to the MMIO analog in
Sends the PC-90 out to the MMIO S/PDIF
Sends the PC-90 out to the MMIO TOSLINK in
Patches the PC-90 output to the LDI-12T analog outputs
Patches the PC-90 output to the LDI-12T S/PDIF outputs
Patches the PC-90 output to the LDI-12T TOSLINK outputs
41