Lexicon 12T User Manual page 35

Destination
<Clear All>
VST_Analog_In L & R
VST_SPDIF_In L & R
VST_ADAT_In 1 - 8
VST_AuxRet_In 1L & R
VST_AuxRet_In 2L & R
12T_Analog_Out L & R
12T_SPDIF_Out L & R
12T_ADAT_Out 1 - 8
The following diagram shows a flow chart of the audio routing from the previously illustrated
control panel. Note that the PC-90 receives its input from Cubase VST via the
V S T _ A u x _ S e n d _ 1 L and V S T _ A u x _ S e n d _ 1 R sources. These sources route any audio
assigned to that bus into the PC-90.
Note also that, as 12T_Analog_Out_L and 12T_Analog_Out_R are selected as PC-90
destinations. The audio is summed with the outputs of Cubase VST, which are also routed to the
analog outputs. This allows monitoring of PC-90 reverb and all audio from VST through the same
outputs of the interface.
For more information on routing and control of your PC-90, see PC-90 Basics: Basic Operation
later in this manual.
Description
Clears all destination assignments
Sends the PC-90 out to the analog in on the VST Input page
Sends the PC-90 out to the S/PDIF in on the VST Input page
Sends the PC-90 out to the ADAT in on the VST Input page
Sends the PC-90 out to Aux 1 in on the VST Input page
Sends the PC-90 out to Aux 2 in on the VST Input page
Patches the PC-90 output to the LDI-12T analog outputs
Patches the PC-90 output to the LDI-12T S/PDIF outputs
Patches the PC-90 output to the LDI-12T ADAT outputs
27