Setting The Channel Counter Sweep Width - Yaesu VX-3R Operating Manual

S C
ETTING THE HANNEL
You may change the bandwidth of the Channel Counter. Available selections are ±5, ±10,
±50, and ±100 MHz (default: ±5 MHz).
Here is the procedure for setting the Channel Counter Bandwidth:
1. Press and hold in the [ TXPO ] key for one second to enter the Set mode.
2. Rotate the DIAL knob to select Set Mode Item 17: CH CNT
Note: Do not forget to pull the DIAL knob to rotate the DIAL
knob.
3. Press the [ TXPO ] key momentarily to enable adjustment of this
Set Mode Item.
4. Rotate the DIAL knob to select the desired bandwidth.
5. When you have made your selection, press the PTT switch to
save the new setting and exit to normal operation.
VX-3R O
PERATING
C
HANNEL
C S
OUNTER WEEP
M
ANUAL
C
OUNTER
W
IDTH
CH CNT CH CNT
CH CNT. CH CNT
O
PERATION
69