Yaesu VX-3R Operating Manual page 119

Set Mode Item 57 [ MSG.SEL ]
Function: Programming a Message for the Message feature.
See page 70 for details.
Set Mode Item 58 [ ON TMR ]
Function: Set the On Timer Time.
Available Values: OFF/00H.10M(00:10) 24H.00M(24:00) (10 minutes/step)
Default: OFF
The On Timer turns on the radio at the programmed time.
Set Mode Item 59 [ OPN.MSG ]
Function: Selects the Opening Message that appears when the radio is powered on.
Available Values: OFF/DC/MSG
Default: DC
OFF: No Opening Message
DC: DC supply voltage
MSG: Set by user. See below.
Here's how to program the Opening Message:
1. Select this Set Mode Item to "MSG."
2. Press the [ V/M ] key momentarily to enable programming of the opening message. You
will notice the first character entry's location blinking.
3. Rotate the DIAL knob to select the first letter/number of the message, then press the
[ V/M ] key momentarily to save the first letter/number and move on to the next charac-
ter.
Note: Do not forget to pull the DIAL knob to rotate the DIAL knob
4. Repeat the steps 3 and 4 as necessary to complete the message (up to six characters).
5. If you make a mistake, press the [ BAND ] key to back-space the cursor; now re-enter
the correct letter/number.
6. When you have entered the desired opening message, press the [ TXPO ] key momen-
tarily to confirm the message, then press the PTT switch to save the settings and exit to
normal operation.
Set Mode Item 60 [ PAG.ABK ]
Function: Enables/Disables the Answer Back function of the Enhanced CTCSS Paging &
Code Squelch.
Available Values: ON/OFF
Default: OFF
Set Mode Item 61 [ PAG.CDR ]
Function: Sets the Receiver Pager Code for the Enhanced CTCSS Paging & Code Squelch.
See page 34 for details.
VX-3R O
PERATING
M
ANUAL
( M
S
ET ENU
) M
ODE
117