Setting The Priority Memory Channel Transmit Operation; Set Mode: Gm Menu Operations; Set Mode: Wires-X Menu Operations - Yaesu FT3DR Operating Manual

7. Rotate the DIAL knob to select the desired setting referring to the table below.
ALL CH Scans all memory channels (1 to 900) starting with the currently speci-
fied memory channel. When "Selected memory channel" is selected, all
specified memory channels are scanned.
BAND Scans only the memory channels to which the frequencies are regis-
tered, within the same frequency band
ory channel.
When the memory channels are registered as the specified memory
channels, scans only the specified memory channels to which the fre-
quencies are registered, within the same frequency band.
*1: For the relationship between frequency bands and receive frequencies, see "Se-
lecting a Frequency Band" on page 24.
8. Press the [BACK] key.
9. Rotate the DIAL knob to select [BANK LINK], then press the [DISP] key.
10. Rotate the DIAL knob to select the desired setting.
ON During memory bank link scanning, memory channels registered in two
or more previously specified banks can be scanned.
OFF Only the memory channels assigned to the recalled memory bank are
scanned.
Remark The default setting: ON

6 Setting the Priority Memory Channel transmit operation

Determines the operation of the PTT switch when pressed during the Dual Receive.
1. Press and hold the [DISP] key, and then touch [SCAN].
2. Touch [6 PRIORITY REVERT].
3. Rotate the DIAL knob to select the desired setting.
OFF When a signal is received on Priority Memory Channel, duel receive
pauses, press the PTT switch to deactivate the Dual Receive operation
and transmit on the Priority Memory Channel.
(The Dual Receive does not resume.)
ON Press the PTT switch to transmit on the Priority Memory Channel.
Release the PTT switch to receive the Priority Memory Channel for
about five seconds, then Dual Receive operation continues.
Remark The default setting: OFF

Set Mode: GM Menu Operations

For details on how to set each item, refer to "FT3DR/DE GM Function Instruction Manu-
al" which is available on Yaesu website.

Set Mode: WIRES-X Menu Operations

For details on how to set each item, refer to "FT3DR/DE WIRES-X Instruction Manual"
which is available on Yaesu website.
76
*1
as the currently specified mem-
*1